<< Click to Display Table of Contents >> Navigation: NxLib API > Tree > PatternBuffer > All > Patterns > 0 > 4002900001 (a monocular camera) > 0 > Pattern > Offset |
Offset of the workspace origin to the pattern center, encoded in the pattern data. This information is necessary to correctly offset the workspace system when calibrating the working plane with a pattern.
Array/Vector |
Offset of the encoded origin to the pattern as a two element Vector. [mm]. |
Note: This node only exists if an offset was decoded from the pattern. It also exists if only a section of an Ensenso pattern was observed, in which case the offset is the offset of the section center to the center of the whole pattern.