<< Click to Display Table of Contents >> Navigation: NxLib API > Commands > EthernetConfiguration > Parameters > MacAddresses |
Specifies the MAC addresses for GigE Vision cameras in a Blind ethernet configuration.
String |
A single MAC address of a GigE Vision camera, specified in the usual format of hexadecimal bytes separated by colons. |
Array |
An array of MAC addresses, each specified as a string. |
If this parameter node is not specified, it defaults to an empty array.
Note: This node is only used when the Blind parameter is set. You cannot specify both the Cameras parameter and this one at the same time.
Note: For each device specified by this parameter, you have to specify a corresponding IP configuration in the Configuration parameter.