N20 Power Supply

The N20 can be supplied with power via Power-over-Ethernet or via 12-24V supply on the GPIO port. On PoE switches the camera registers as PoE class 3 device (6,49 - 12,95 W)

Examples of possible power supplies are:

• Connect the N20 to a PoE compatible switch or use a PoE injector

• Connect the M8 Power Adapter via the M8-Hirose 6-pin Adapter to the N20

• Supply 12-24V via a custom cable on the Hirose HR10 connector

Note

• The camera has an inrush current demand of up to 2A on connection and on opening the device from a computer. During these times the supply voltage on the GPIO port must not drop below 11V for correct operation of the camera. For seamless operation, especially with long supply wires, we therefore recommend to connect the camera to a 24V supply for sufficient voltage reserve.

• When the camera is connected to a PoE compatible switch and voltage is also provided on the GPIO connector the power supply over PoE will be preferred.