Wiring for Hardware Synchronization

To synchronize the cameras you have different possibilities:

• Enable the trigger output on one of the cameras and set all other cameras to hardware triggered on the falling edge. The camera outputting the trigger signal can then be operated software triggered, and all other cameras will operate synchronously to this camera.

• Supply an external trigger signal via another Y-Adapter. In this case all cameras should be set to hardware triggered.

Note

The internal electrical connections of all cables used in the following figures are described under the cables topic.

Note

See the detailed topics for cable schematics.

Power Supplies

• M8 power supply

M8 Adapters/Extensions

• Extension cable

• Cable with open endings

• Sync adapter

Model Specific Adapters

• uEye CP2 adapter

• uEye CP1

• uEye FA adapter

• M8/M12 adapter