Mode

Specifies how the output is set.

Format

String	“Low”	Permanently set the output to low.
	“High”	Permanently set the output to high.
	“LowActive”	Configure the output as a low active flash output that can be used to trigger other cameras or devices. Use the Duration node to change the duration of the signal.
	“HighActive”	Configure the output as a high active flash output that can be used to trigger other cameras or devices. Use the Duration node to change the duration of the signal.
	“PWM”	Sets the output as output for the pulse-width modulation. Use the Frequency and DutyCycle node to change its parameters.

Note

For N20, N3x and N4x cameras only the “LowActive” mode is supported.