<< Click to Display Table of Contents >> Navigation: Hardware Specification > Electronics / GPIO > N20 GPIO |
The GPIO port uses a male Hirose HR10 6-pin connector and can be used as input and output. Input and output can be used at the same time and are connected to the camera's internal logic by optocouplers.
1 |
Ground (GND) |
2 |
Power Supply 12-24V DC |
3 |
Digital Input - |
4 |
Digital Input + |
5 |
Digital Output + |
6 |
Digital Output - |
Note: The connector and pinout is identical to IDS GigE uEye CP cameras.