Mode

Specifies how the output is set.

Format

String

“Low”

Permanently set the output to low.

“High”

Permanently set the output to high.

“LowActive”

Configure the output as a low active flash output that can be used to trigger other cameras or devices.

Use the Duration node to change the duration of the signal.

“HighActive”

Configure the output as a high active flash output that can be used to trigger other cameras or devices.

Use the Duration node to change the duration of the signal.

“PWM”

Sets the output as output for the pulse-width modulation. Use the Frequency and DutyCycle node to change its parameters.

Note

For N10 cameras, the output can only be actively driven into high state. The “HighActive” mode is not supported. When the output is set to low it can be driven high or pulled low externally and act as input. Refer to the electrical specification for wiring details.

Note

For N20, N30 and N35 cameras only the “LowActive” mode is supported.