Mode¶
Specifies how the output is set.
Format
String |
“Low” |
Permanently set the output to low. |
“High” |
Permanently set the output to high. |
|
“LowActive” |
Configure the output as a low active flash output that can be used to trigger other cameras or devices. Use the Duration node to change the duration of the signal. |
|
“HighActive” |
Configure the output as a high active flash output that can be used to trigger other cameras or devices. Use the Duration node to change the duration of the signal. |
|
“PWM” |
Sets the output as output for the pulse-width modulation. Use the Frequency and DutyCycle node to change its parameters. |
Note
For N20, N30 and N35 cameras only the “LowActive” mode is supported.